| Aero 48 Line Array Speaker | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
The Aero 48 is an externally powered, high efficiency line array module which integrates low, mid and high frequency transducers in a single unit. The rugged, trapezoidal enclosure is easy to transport thanks to the front located dolly panel. Captive rigging hardware keeps all parts in place and makes joining one box to another safe and simple. |
|||||||||||||||||||
The 3-way full range passive loudspeaker for triamplified use shall incorporate two 15 inch cone low frequency transducers, two 8 inch cone low frequency transducers and two 1.5 inch throat drivers coupled to respective aluminium plane wave adaptors mounted to a common horn. The frame of the low and mid requency speakers shall be manufactured of die-cast aluminium. The low frequency voice coil shall be 4 inches in diameter. The mid frequency voice coil shall be 2.5 inches in diameter. The high frequency voice coil shall be 3 inches in diameter and the diaphragm shall be constructed of titanium. All transducers shall use Neodymium magnets.
The system specifications of a typical production unit shall be as follows: Average (RMS) power handling shall be 1200W for the low frequency section, 700W for the mid frequency section and 300W for the high frequency section. IEC on-axis frequency range shall be of 45 Hz to 18 kHz. On-axis sensitivity (1W / 1m) shall be 99 dB SPL for the low frequency section, 104 dB SPL for the mid frequency section and 112 dB SPL for the high frequency section. Nominal impedance shall be 8 ohms for each driver of low frequency section, which are wired separately, 8 ohms for the mid frequency section and 16 ohms for the high frequency section.
The system’s low frequency drivers shall be mounted as direct radiators into a bass-reflex cabinet constructed of Wisa(R) plywood. It shall be finished with hardwearing catalyzed polyurethane paint. Two hand locations shall be provided. The front of the system shall be protected with a perforated steel grille, sealed against corrosion using a polyamide powder coat finish, and covered with acoustically transparent fabric. The system has built-in rigging hardware for hanging into line array format. Computer software for line array design is available.
The system shall be a D.A.S. CA-48.
| RELATED ITEMS | |
|---|---|
![]() |
AX-AERO-48 Rigging frame for Aero 48 $1,148.00 |
![]() |
AX-COMBO Rigging frame for flying CA-28/CA-28A/CA-28B below Aero 48 $455.00 |
![]() |
PL-48 Front Dolly Panel |
![]() |
PL-48S Metallic Transport Dolly $1,081.00 |











